38192 Main Plot Control MPC: The <Plate identifier> is positioned <Error distance> mm too close to the <Error direction> side Gravure Japanese_Newspaper_OEM_Engine Lotem_400_Fiber_Head_Machine Lotem_800_Fiber_Head_Machine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 The plate is positioned incorrectly along the drum. This could result in either failure to find the edge, or the plate not sitting on the required registration pins. Ensure that the plate is loaded in the correct position along the drum for the particular plate dimensions. Ensure that the plate dimensions specified in the job match the physical plate dimensions. This error is reported. The head is over the plate at the minimum edge search position No edge has been detected up to the maximum edge search position The plate is not positioned over the correct registration pins The plate dimensions specified in the job do not match the physical plate dimensions Plate identifier This is either "home", "away" or nothing, depending on how many plates are loaded and which plate is wrongly positioned. Error distance This is how far away from the ideal position the plate is actually positioned. Error direction This indicates which direction the position error is in, either "home" or "away". 13-Jun-2006 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:11 2008 PST